Clarifying an M3?

Part No's.

Lights off side 63171381419 near side 63171381420

frames 63171375051 x2  bracket's 51111940377 x2

screw's 63171367315 x4 in total should not be more than £60/70 from the dealer, all part's still listed

Like I said, the lights are the same as pre-facelfit E30, just look under any E30 made before 1987, and they are the lights you need.

The rest is available from the dealers, I know because I bought some about 6 months ago, and came to my senses and decided to stick with the brake ducts.

Some of the lad's may have a set going, as a lot take them out to put air intakes in for the front brakes.

If not you will need the light's, frame's and bracket's, the wireing should be insitue so I recon if you want to do it you will be looking at £70 to £90 all done.

You can still get all the part's, if you want the part nos. give me a shout

Impressive job Craig , lots of interesting points raised .

Look forward to seeing the finished car !

cheers

Andy

HI ron,

well, its looking firm for a respray this weekend,

Leathers are taking ages, but should be done by then and fitting them is no issue.

I basically expect the car to be nearing "visual" completion by then, but i doubt the engine will be in. I get home latish on most evenings, and only have the weekends to work on it of which sunday is useless after 2 due to family arrangements etc.

Im getting there as fast as possilble, and will be very very dissaponted if i miss much of this summer.

Are you hinting at showing the car, not sure if it would be worth trailering it there with no engine?

The car isn't going to be a show car, as in its finish, its finished to a very good standard, but as you probably know the finishing was done by me (unqualified!), so close examination will reveal this.

Let me know if you have anything in mind.

Ok, so i take it the control arms are the same though, as you always hear of people looking for the aluminium type if possible.

Yes, the bars on the front i have shown in the picture have about a 6mm wall thickness. They are ridiculously stiff, i cannot make them twist or deform in any way.