E36 Air Lock |
Post Reply |
Author | |
andybeemer74
Really Senior Member I Joined: 04-June-2009 Location: The Toon Status: Offline Points: 494 |
Post Options
Thanks(0)
Posted: 16-February-2014 at 17:43 |
Hi all I have an E36 323i saloon radiator was leaking so I fitted a new one whilst I had it apart I fitted new water pump and new thermostat. Once all back together I am having a nightmare bleeding the water system. The temp goes up to half way and stays there heaters are blowing cold I have had all hoses off and seem to be getting water to all parts of engine etc. It runs fine temp doesn't go up or down but when I remove radiator cap it throws water up in the air and just keeps pressurising, I took thermostat back out and checked it in a pan of boiling water and its opening fine so im thinking head gasket now although after speaking to a few people apparently they can be a bugger to bleed any help would be appreciated cheers Andy.
|
|
Half Jock :-) |
|
Sponsored Links | |
Robin814
Really Senior Member I Joined: 15-May-2011 Status: Offline Points: 385 |
Post Options
Thanks(0)
|
I can't really help you mate. But just to confirm what you say BMW are murder for air locks in the coolant system.
|
|
E46 318Ci M Sport 2001 Light Gelb
E39 530I Champagne I Individual Edition 2002 |
|
Andrew Rolland
Moderator Group Go away rain Joined: 19-August-2004 Location: Scotland Status: Offline Points: 6579 |
Post Options
Thanks(0)
|
Yip The M52 engiens are a nightmare to bleed. The problem is that the expansion tank level is lower than the top of the water level in the radiator.
Have a read of this post, the second page on how I replaced my water pump in the same engine and then re-filled the system.
I ended up filling the system thru the bleed screws which are on the expansion tank top and the thermostat housing.
From memory TIS (BMW) say to fill the system then leave the expansion tank cap off and sharlpy rev the engine a couple of times with the heater on full.
Recently working on the father in laws 1.6i Volkswagen engine cooling system, we got rid of an air lock by revving the engine, we knew it had air locked as the heater was cold, the pipes to his heater go out of the engine an upwards at the bulkhead then fall down to the heater, but the highest point of the heater hose is again like your BMW, is higher than the expansion tank level.
|
|
Be exclusive and drive a Petrol 5 Series!
Current '13 62 F10 535i MSport Auto Previous '04 04 E60 545i SE Auto '03 53 E60 545i SE Auto (Stolen) '98 S E39 523i SE Auto |
|
sailorbaz
Really Senior Member II (Former) Scottish Region Wean Joined: 02-August-2003 Location: Northern Ireland Status: Offline Points: 961 |
Post Options
Thanks(0)
|
I remember having similar problems on a 318 a few years ago. Seem to remember removing the top hose from the radiator and filling very slowly helped somewhat. I think you can remove the top hose and rotate it to make pouring water into the engine easier. The secret was filling it very slowly. Also, having it jacket up at the front as said to help getting rid of the air in the system.
I'm sure it is just air in the system, I wouldn't be jumping to head gasket problems just yet. |
|
Post Reply | |
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |