Suspension - When to tell if worn |
Post Reply |
Author | |
Stay Alive
Senior Member I Joined: 02-November-2003 Status: Offline Points: 111 |
Topic: Suspension - When to tell if worn Posted: 30-November-2004 at 13:46 |
Does anyone know how you can tell if your suspension is worn to the point where the struts will need replacing. It just my E36 318Ti Compact appears to be rolling slightly around corners and the back end comes out a little to easy for me in the wet. In case it is just me I would like to know if there is a simple way of testing. Measurements between the wheels and arches are the same all round but that doesn't mean this is OK as they could have all worn the same? Couldn't they? Any help would be greatful. PB |
|
Sponsored Links | |
Peter Fenwick
Bavarian-Board Contributor Joined: 27-August-2003 Location: Lost somewhere in time... Status: Offline Points: 6484 |
Posted: 01-December-2004 at 04:49 |
The E36 compact had the same rear suspension as the E30 so it will be a bit tail happy in the wet. You can tell if the struts need replacing by pushing down on each corner of the car. If the body comes back up and stops then the strut is Ok, if if bounces up and down a bit then the strut is knackered. One of my struts was shot and it was very noticable when driving the car, i.e it was very difficult to control when driving down a bumpy road. measurements between arches and tyres doesn't really tell you a great deal other than if you springs are starting to sag. |
|
Entering an age of Austerity and now driving a Focus Diesel.
|
|
Stay Alive
Senior Member I Joined: 02-November-2003 Status: Offline Points: 111 |
Posted: 01-December-2004 at 05:49 |
Thanks for that Peter. I guess I need new struts because they do bounce a little when you press down on them. Don't supose you could recommend suitable replacements? Regards |
|
Peter Fenwick
Bavarian-Board Contributor Joined: 27-August-2003 Location: Lost somewhere in time... Status: Offline Points: 6484 |
Posted: 01-December-2004 at 06:19 |
Bilsteins are good. I have their sport dampers on the front of my car.
|
|
Entering an age of Austerity and now driving a Focus Diesel.
|
|
Madrab
Really Senior Member II Joined: 21-November-2003 Location: Scotland Status: Offline Points: 569 |
Posted: 01-December-2004 at 08:20 |
Maybe also worth getting the roll bar and bushes checked, as they, as the name suggests, control the roll of the car. They can also get tired with loads of miles. The rule I follow for suspension is - The springs control the ride of the car and the shocks control the springs. If the suspension is getting softer then the springs may be getting tired. As Peter says though, if you are getting rebound when you press the car down and it doesn't stop after the first bounce then the shocks could be getting worn too. Rob |
|
1990 E3o 325i Touring and she's definately a she! Pain in the ass sometimes but goes like a bunny :oD
|
|
Stay Alive
Senior Member I Joined: 02-November-2003 Status: Offline Points: 111 |
Posted: 01-December-2004 at 08:35 |
I hear what you are saying despite the fact I am now confused. I presume the bushes are checked via visual inspection whereby I am looking for cracks in the rubber??? I think I will have a professional check out the whole suspension. |
|
SkyRocketeer
Groupie Joined: 16-November-2004 Location: Bristol Status: Offline Points: 45 |
Posted: 01-December-2004 at 18:38 |
In my experience, anti-roll bars themselves rarely 'wear' in a sense
that they change their performance. The bushes may become slack and
sloppy through age, but the roll bar, if it's intact, won't adversely
affect performance as it ages. Usually replacing the bushes is
sufficient, a visual inspection is a good start, but a skilled mechanic
with a lever or pry-bar will tell you which bushes have too much play.
Most likely candidates for age related poor performance are likely to be shocks. typical german shocks (Boge I think are OE suppliers) will last over 100k without leaking, but the damping ability drops off a lot sooner. The 'bounce test' as described earlier is a good and easy way to check on their performance. From release the car should complete one to one and a half oscillations (i.e up-down-up) on good shocks. More than that indicated they're getting tired.. mine bounces for about a week, but I'm guessing at 127k it's not seen new shocks at all [shrugs] New shocks may raise the ride-hight slightly, especially if the old ones were leaking, as they offer a slight sprung resistance as well as damping. |
|
Rhys
Moderator Group Coffee addict... Joined: 02-February-2003 Location: from the Latin locātiō Status: Offline Points: 10053 |
Posted: 01-December-2004 at 19:42 |
Another ti owner
|
|
V reg Rustbucket Merc C220 Cdi estate
J Reg Saab 900i 16v '63 Ford Anglia 105e deluxe R reg Honda PC50 moped.. No BMW as yet... |
|
Stay Alive
Senior Member I Joined: 02-November-2003 Status: Offline Points: 111 |
Posted: 02-December-2004 at 05:45 |
Thanks for that Skyrocketeer. A bit more clearer again.
|
|
M3AG
Really Senior Member II 7 series & e36 m3 registrar! (Madness) Joined: 17-October-2002 Location: Good Old Hertfordshire Status: Offline Points: 1644 |
Posted: 02-December-2004 at 06:08 |
Don't forget to have the rear top mounts checked, if worn they can lead to knocks from the boot area and some strange behaviour where handling is concerned. Same with trailing arm bushes (which make the arm move if damaged and therefore upsetting the geometry of the suspension).
|
|
Hans Freikit
Senior Member I Joined: 05-February-2004 Location: United Kingdom Status: Offline Points: 143 |
Posted: 02-December-2004 at 06:22 |
Ditto on the rear shock mounts - one of mine has started knocking at 80k miles. The E36 can use improved parts from the E46 as direct replacements, and Z3 reinforcement plates for extra longevity. http://www.uucmotorwerks.com/html_techtip/techtips/rear_shoc k_mounts.htm HF |
|
Madrab
Really Senior Member II Joined: 21-November-2003 Location: Scotland Status: Offline Points: 569 |
Posted: 03-December-2004 at 08:38 |
I wouldn't necessarily agree with not checking the roll bar itself. If the car has had heavy use and done a lot of miles then bars can undergo straightening which, in effect, can 'flatten' the bar and reduces antiroll strength.This can increase roll as the bars 'push back' can be compromised to some degree. Usually seen as surface flaking of the metal of the bar. Ever replaced a stock roll bar on a car with 130k hard miles and placed the new and old side by side? Can be quite a difference in shape and performance. I would agree that replacing other components first can reduce the slackness due to tightening the overall suspension system and can negate a slightly tired bar's give. This can then transfer higher loads to the suspension increasing the wear rates. I suppose this could be the last part of the suspension replacement though and could rule this out last. Edited by Madrab |
|
1990 E3o 325i Touring and she's definately a she! Pain in the ass sometimes but goes like a bunny :oD
|
|
Post Reply | |
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |